All Windows Are In

I purposely waited until the window install project was completely finish before posting any pictures. I wanted to show a series of the steps of the install and I wasn't able to finish the exterior painting until the weekend. But trust me, I was busy during the week scraping up the last of the nasty linoleum residue. Not to mention being busy drinking beer and watching St. Louis beat out Detroit in the World Series.

And that's not the only thing St. Louis has beaten Detroit out on, if you've seen the latest top 10 list...

One Window In, One More To Go

Today I spent 4 hours installing a Jeld-Wen casement window. Though it seemed fairly complicated from the 8 pages of installation instructions at first, it was really quite simple. Of course, I still have to reinstall the house wrap and siding as you can see from the following picture:

Fortunately, Portland is getting dry warm weather for the next 2 days so I got lucky. However, that brings a pretty solid east wind, which creates a slight challenge. The next window won't be so easy either. I have to rebuild the rough opening to make the inside trim symmetrical. The original windows had one window installed an inch higher than the other, plus one side of the bay window is a little wider than the other.

And this was done before crack was invented!

Conversation with Previous Owner

The other night I was going through my house information on the computer and came across these notes I took after speaking with the previous owners on January 20, 2001:

They bought the house in 1964 for $7500 and sold it for $18,000 sometime in the mid seventies. Today, it's listed on zillow for over $325K.

The house was heated by oil and had a tank in basement, which one time overflowed and went all over the floor. Today, it's now forced air gas and the only thing that spills is some paint from time to time.

In 1967, they installed aluminum siding. They removed the old asbestos siding and it cost them $5000. She said that the wood siding underneath is most likely in good shape as her father was good about removing rot. Today, the exterior is the original dutch lap siding that I restored in summer of 2001. I removed that same aluminum siding that they installed 34 years before.

In 1969, the day man first walked on the moon, they put the sidewalk from the front door to the street in. Her kids did their hand prints and names (Tommy and Bobby?) just to the right of the front door as you’re facing it. They were the ones who opened up the staircase. They had the 50’s style cone shaped fireplace on the woodstove area. Today, it is....

















The dining room was supposedly the original house. They also removed old french doors in dining room and installed the sliding door. They said they had found square nails in the door frame. Today, I'm planning on removing the sliding glass door they installed and installing french doors.

They had poured the concrete off the dining room for the patio. Today, the concrete exists but was broken up in 1999 and reinstalled with creeping thyme planted in the cracks.

The back utility room was put up by them. They also gutted and refinished the kitchen and the bathroom. There was a fire before them in the back porch area. They had dug out the basement crawl space, and they installed a roof in the early seventies but they knew someone had put the brown roof on after them. In 1997, I had to have a new roof put on. There were FOUR layers of previous roofs. The bottom being wood shingles.

There was no 6-foot fence but rather hedges all around. There was also a garage in the back. Today, it's just grass, a waterfall, and a lattice shed in the back.

In 1966, they planted the cherry tree. Today, it's HUGE.

Their kids used the attic above the kitchen as a play area and they put a floor in there. Today, it is a second bathroom and part of an enlarged bedroom.

Day Two of Adhesive Removal

Tonight I was able to get the bulk of the adhesive removal done. It's not much to look at, but here it is:

Not all of it is coming off, so I'll have to go back and apply the nasty removal stuff in spots. Good times.

Adhesive Removal

I started on removing the glue backing of the linoleum tiles tonight. And with plenty of ventilation. It seems to work fairly well, and with less labor than removing the tops of the linoleum which is nice. I just slap a bunch of some nasty adhesive removal on the backing, place plastic over it, roll it out with a brush roller and wait 30 mintues.

After the 30 minutes is up, I use a sidewalk scraper rather than a putty knife to avoid close fumes, and it seems to come up enough to get it ready for sanding.

Just a patch to go

Here's where I am at. I thinking I can get this last patch of lovely linoleum off in a couple of hours. There is some also other little "patches" to tend to, but will be a piece of cake.



Then, it's to the gummy paper backing removal. See all that black stuff? Below it, is a beautiful douglas fir floor. I just have to keep remembering that.

Linoleum Removal

For the last five days, I've been chipping away at removing the linoleum from the wood floor, working anywhere from 1 to 2-1/2 hours per night. It's not as bad as I was expecting it to be, but it's also not that fun. Of course, it's exciting to slowly see the wood floor become uncovered. I think it will be worthwhile.

I'm totally going to hell

Or my house is going to burn like hellfire damnation.

I sent in my questioneer to my insurance company for the woodstove and I lied. Sort of. On the part when they asked when the stove was installed, I put “unknown” as if the stove was in already when I got the house, which isn’t true. But it’s not completely untrue either, because I have NOT installed the stove yet. And I don’t know WHEN I’ll install the stove. So, “unknown” is nearly the correct answer.

I am usually a by-the-book kind of person when it comes to structural and fire safety, but with my 4” x 8” ID chimney, there is no way I’ll be able to install a liner in the chimney, which is required by code. So, I will not get this inspected when it’s complete, because I know it won’t pass due to the lack of liner.

I questioned an inspector over the phone what the danger was with an unlined chimney and he stated Carbon Monoxide poisoning. That is certainly a danger, but with a detector, I felt it wouldn’t be worth tearing down and rebuilding a 16’ chimney. I am, however, following every other rule made by Portland code like the 1” space, non-combustible wall, hearth, annual chimney cleaning, etc.

So, I’m going to see if I can slip this through. I figured if a wood stove worked in this house at one time, why can’t it now?

Good Customer Service Wins

Of the 5 door and window distributors that I called, 3 of them called me back. 2 of those 3 were fairly close to where I live but unfortunately, their customer service was poor. They either didn't return specific questions regarding the doors, or just took too long in calling back. So, I finally got the door and windows ordered through Parr Lumber up on Killingsworth and MLK. They'll even deliver to the house, so the whole locality thing didn't even come into play.

As for the current project I'm working on, the linoleum removal, it hasn't been as boring as I thought. I have 2 hours into it so far, and would expect a good 12 hours left. The process is to first try with a wonder bar that is great with removing the somewhat loose tiles. If that doesn't work, I throw a wet towel over the tile, and heat it up with an iron. Then use a putty knife to scrape the top of the tile off. Later, I'll have to go back over those sticky tiles with adhesive remover.

I expect my arms to be massively huge when it's all said and done.

Here's where I'm at as of 9pm Monday the 3rd: