After doing the kitchen remodel and adding a new fridge, I held onto the older fridge because I've always entertained the idea of a kegerator. Not only is it convenient, but also saves money and I can have just half glasses if I want.
The basic set up of the tap out of the front door was very easy. I literally think it took less than 45 minutes. I mentioned "convenience" earlier. That was only in respect to not having to buy and recycle beer bottles every week. But the kegerator was located in the basement, and that is not so convenient....until now.
Now, I've made it so I have beer coming out of the kitchen wall!
|Now you don't see it.|
|Now you do.|
After some research
and discussion with bar owners
, I had a solid plan. I bought a small blower and made sure it didn't heat up too much when operation, then cut an opening in the floor, ran 3" insulated duct from the kegerator side to the back side of the wall. Inside the 3" duct is a beer line and a 1" tube connected to the blower which sits on a ledge in the fridge and cools the 3" duct. It works fairly slick, though there is a little foam due to the increase pressure needed to overcome the 10' lift. But the convenience is great, not to mention a slight cool factor...
Here are some detail internal snapshots:
|50 cfm blower in fridge|
|1" tubing connected to blower and ran to upper floor|
|1" tube and beer line runs inside a 3" duct covered by insulation connected to fridge side|
|2nd level continuation of 3" duct inside wall terminates to sealed box|
|View inside sealed box showing end of 1" tube and beer line|
Labels: KItchen Remodel